Roof Replacement in Cranford, NJ
Cranford, NJ
We just wrapped up replacing a roof in Cranford, NJ. It was a full replacement to keep the house safe and looking good.
The Challenge
We had to carefully take off the old roofing. Taking stock of the layout helped us prep for the new roof.
The Solution
Our crew got the new roof on in a few days, making sure everything was installed right.
Materials Used
Asphalt shingles — architectural, three-tab, or designer. Starter-strip shingles — installed along eaves and rakes. Hip and ridge cap shingles — finish hips and roof peaks. Synthetic underlayment or roofing felt — protection beneath shingles. Ice and water shield — waterproofing at vulnerable areas. Drip edge — metal edging along eaves and rakes. Valley flashing or valley membrane — based on the valley installation method. Step flashing — where the roof meets sidewalls. Apron and counterflashing — for walls and chimneys, as applicable. Pipe boots — seal around plumbing vent pipes. Ridge vents and intake vents — provide attic ventilation. Roofing nails — sized for the shingles and roof deck. Cap nails — secure underlayment. Roofing sealant or cement — compatible with the roofing system. Plywood or OSB roof decking — replace damaged sections. Decking nails or screws — secure replacement sheathing. Skylight flashing kits — if skylights are present. Ventilation baffles — where needed to keep soffit airflow clear.
Project Photos
Frequently Asked Questions
A permit isn’t needed unless you’re replacing the sheathing across the whole roof.
Typically, it takes about 1 to 3 days, depending on the roof size.
We usually use asphalt shingles and put an ice and water barrier underneath.
More from Herts Roofing & Construction